• Fully Digital "All-in-One" Design

• LED Bar Display of % IR Input Signal

• Programmable 250°C to 1000°C Trip Level

• Operates from 80-240VAC, 24VDC Supply

• Remote Lenses Options: 1°, 2°, 4°, 7° F.O.V. Spot or 1/2° x 25° F.O.V. Precision Slit Rectangular.

• High Temp. Lens Ratings of 180°C, 400°C or 1000°C.

• Programmable Response Time from 1 to 250 msec.

• Control Relay and Fast Reed Relay Outputs.

• Both NPN and PNP Transistor Outputs..

• Remote Self-Check Facility.

• Robust lens mounts are available including air purged, air cooled and water cooled.

• Detection of Hot Metal or Hot Product in a Rod Mill, Bar Mall, Rolling Mill, Plate Mill, Roughing Mill, Hot Strip Mill or other Steel Mill and Industrial Applications.
  

  The MD95100 fully digital “All-in-One” Hot Metal Detector incorporates a bar display showing the IR input signal relative to the pre-set trip level as well as selected programmable thresholds and response times via simple external programming switch action. Operates via highly sensitive and stable InGaAs Photodiode, detection is assured via the heaviest water and steam.
  
  The MD95100 utilizes a modular digital Controller in protective mounting Cradle, flexible armored optic leads and interchangeable Remote Lenses. As the controller can be used in conjunction with any lens option one standard controller can be used throughout the mill. Now there is no need to stock a detector for each requirement. Costly multiple inventory can be replaced with one detector.
  
  A wide variety of remote lenses impervious to water & steam are built to withstand the harshest environments are available. Used in conjunction with flexible armored optic leads, these lenses provide a high level of optical accuracy by allowing the selection of the ideal lens arrangement for the installation. Robust lenses with temperature ratings of 180°C, 400°C and 1000°C can be mounted close to the hot product. Various robust lens mounts are available including air purged, air purged with air cooling and air purged with water cooling.
  
  The remote lenses incorporate filters to minimize sensitivity to extraneous light. For general tracking, spot lenses are commonly used. Where high accuracy is required or the product deviates about the center line (i.e. Rod Mill) a ½° x 25° precision slit rectangular lens should be utilized. This lens is also highly suited to Strip Mills. Also available is the 1000°C Shrouded Quartz Rod Lens, specifically engineered for mounting in the harsh and high ambient environment below the line or inside the mill stand.
   

MD95100